writeInputTS {antaresEditObject}

Write input time series

Description

This function writes input time series in an Antares project.

Usage

writeInputTS(
  data,
  type = c("load", "hydroROR", "hydroSTOR", "mingen", "wind", "solar", "tsLink"),
  area = NULL,
  link = NULL,
  overwrite = TRUE,
  opts = antaresRead::simOptions()
)

Arguments

data

A 8760*N matrix of hourly time series, except when type is "hydroSTOR". In this latter case "hydroSTOR" data must have either be 365 rows (Antares v7) or 12 rows (v6 and earlier).

type

Serie to write: "load", "hydroROR", "hydroSTOR", "wind", "solar", "tsLink" or "mingen".

If type == "mingen", "antaresVersion" should be >= 860. Refers to note section below.

area

The area where to write the input time series.

link

Link for which writing transmission capacities time series, must like "area01%area02" or "area01 - area02" or c("area01", "area02").

overwrite

Logical. Overwrite the values if a file already exists.

opts

List of simulation parameters returned by the function antaresRead::setSimulationPath()

Value

An updated list containing various information about the simulation.

Warning

You cannot use area and link arguments at the same time.

For an Antares version >= 860, control of data consistency between mingen.txt and mod.txt can be executed.

These controls depend on the values you find in hydro.ini file.

Note

For an Antares version >= 860, the mingen.txt file is created.

The mingen.txt file can be created under two conditions:

• The number of columns must be equal to either 1 or the number in mod.txt

• If the mod.txt file is empty or has one column, then there is no dimension constraint

Examples

## Not run: 

# Write solar time series
writeInputTS(
  area = "fictive_area",
  type = "solar",
  data = matrix(rep(4, 8760*2), nrow = 8760)
)


## End(Not run)